Skip to main content
Skip table of contents

Additional Features

Data Reset

The data can be removed from the Sunforest device which will reset the number of readings back to ‘000’. This can be helpful to easily keep track of the number of readings taken throughout a day.

How to reset the data:

  1. Press and hold the ‘D' button until the three digits towards the top-left on the LCD begin to flash

  2. Press and hold the 'D' button again to reset the number and exit the mode

Buzzer Control Menu

This feature is only available with firmware v9.1

Buzzer control has now been added in the new firmware. Buzzer volume can be adjusted by 3 steps (High, Low, Off)

How to adjust the buzzer volume:

  1. Press and hold the ‘M' button until the device beeps and ‘MODE’ begins to flash

  2. Press the ‘M' button again until ‘CAL’ begins to flash

  3. Press the ‘M' button once more to enter the buzzer control menu

  4. Press the arrow buttons (< >) to select the desired mode

image-20240521-051319.png

‘bon’ = Buzzer volume high

image-20240521-051400.png

‘bLo’ = Buzzer volume low

image-20240521-051352.png

‘boF’ = Buzzer volume off

  1. Press and hold the ‘M' button to set the mode

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.